f3gh54ehyx|1000C140cn_category|p_desc
f3gh54ehy8|0000C140CBE9|cn_category|p_desc|F621E88E-D2E3-480F-9F7C-FC25919FCCDB
" /> UM2102S-电平转换器-接口-英联产品-英联
首页 > 英联产品 > 接口 > 电平转换器
UM2102S
用于漏极开路和推挽应用的2位双向电压电平转换器
Datasheet Reliability Report Package Information Order Sample  
Key Specifications
Part Number Description Status VCCA(Min)(V) VCCA(Max)(V) VCCB(Min)(V) VCCB(Max)(V) Max Data Rate(Mbps) No. of Bits Operating Temperature Range(℃) Pin/Package EV Kit Available?
UM2102S 用于漏极开路和推挽应用的2位双向电压电平转换器 ACTIVE 1 3.3 1.8 5 66 2 -40 to 85 6/SOT23 Y
View All>>
Product Description
 
Pull-up resistors are required on both sides to provide the logic HIGH levels on the translator’s bus. The size of these pull-up resistors depends on the system. The device is designed to work with Standard-mode, Fast-mode and Fast-mode Plus I2C-bus devices in addition to SMBus devices. The maximum frequency is dependent on the RC time constant, but generally supports > 2MHz.
When the SDA1 or SDA2 port is LOW, the clamp is in the ON-state and a low resistance connection exists between the SDA1 and SDA2 ports. Assuming the higher voltage is on the SDA2 port when the SDA2 port is HIGH, the voltage on the SDA1 port is limited to the voltage set by VCCA. When the SDA1 port is HIGH, the SDA2 port is pulled to the drain pull-up supply voltage (VCCB) by the pull-up resistors. This functionality allows a seamless translation between higher and lower voltages selected by the user without the need for directional control. The SCL1/SCL2 channel also functions as the SDA1/SDA2 channel.
All channels have the same electrical characteristics and there is minimal deviation from one output to another in voltage or propagation delay. This is a benefit over discrete transistor voltage translation solutions, since the fabrication of the switch is symmetrical.
The translator provides excellent ESD protection to lower voltage devices, and at the same time protects less ESD-resistant devices.

Features
 
-Less than 3.5ns Maximum Propagation Delay to Accommodate Standard-Mode and Fast-Mode I2C-Bus Devices and Multiple Masters
l-Open-Drain I2C-Bus I/O Ports (SCL1, SDA1, SCL2 and SDA2)
  Provides Bidirectional Voltage Translation with no Direction Pin
-Low 3.0Ω ON-State Connection between Input and Output Ports Provides Less Signal Distortion
-5V Tolerant I2C-Bus I/O Ports to Support Mixed-Mode Signal Operation
-Lock-up Free Operation
-Flow through Pinout for Ease of Printed-Circuit Board Trace Routing
-ESD Protection :
Exceeds 2000V HBM per JESD22-A114
200V MM per JESD22-A115
1000V CDM per JESD22-C101
-Package Offered: SOT23-6
 
Typical Application Circuit


 
  
Applications
 

-I2C, SMBus and SPI Level Translation
-Low-Voltage ASIC Level Translation
-Smart Card Readers
-Cell-Phone Cradles
-Portable POS Systems
-Portable Communication Devices
-Low-Cost Serial Interfaces
-Cell-Phones
-GPS
-Telecommunications Equipment
 
Pin Configurations


                              UM2102S
 
Ordering Information

Part Number
Packaging Type
Marking Code
Shipping Qty
UM2102S
SOT23-6
UCD
3000pcs/7Inch
Tape & Reel
Application Notes
微处理器超长启动周期中的外部看门狗管理方案v2.pdf
利用3.3V供电RS485接口实现远距离数据通信.pdf
高速低电源电压逻辑电平转换电路.pdf
超低功耗LDO线性稳压器.pdf
I2C-BUS电平转换芯片在安防产品的应用.pdf
0201超小封装ESD保护器件.pdf
Analog Switch Permits Port Sharing in Portable Equipment.pdf
Balanced Modulator Demodulator Employing UM4684.pdf
Level Shifter for High Speed and Wide Voltage Range Interface.pdf
Low Resistance Analog Switches Permit Speaker Switching in Audio Devices.pdf
Low-Icct Analog Switches for Ultra-Portable Designs.pdf
Selecting the Right CMOS Analog Switch.pdf 未填写
Product Selection Guide
Interface and System Interconnect Selection Guide.pdf
Product Search
Parametric Search
Product You Recently Viewed
@2014 Union Semiconductor Limited. All rights Reserved.
FOLLOW US